- Member ID
- #2060
- Messages
- 2
- Reactions
- 3
- Likes
- 2
- City
- Las vegas
- State
- NV
- Country
- United States
- Vehicle
- 2018 Hellcat widebody
2018 Hellcat challenger widebody.
Weldcraft would add the extra inch to the back half of the wheel. Using weldcraft because I'd like to keep the stock wheel rather than use an aftermarke wheel.
Will I have enough clearance on the inside? I'm assuming the ouside wheel /tire edge will sit similar to where it is now? I dont want it sticking out much further or past the fender.
Would the revised specs on this wheel, after widening, be a 12 inch wheel with approx et23?
I know guys like D'Gatzby, Paul @ pk Auto Design have a ton of knowledge about these cars, especially regarding tire fitment/performance. Any info would be greatly appreciated. Thanks to all the guys that post regularly on this board. I've been reading it for years. You're a great source of information for Hellcat owners.
Shout out to cole3986, tricolorpit, Djason, cra97 and all the guys searching for traction with wider rubber😁
Weldcraft would add the extra inch to the back half of the wheel. Using weldcraft because I'd like to keep the stock wheel rather than use an aftermarke wheel.
Will I have enough clearance on the inside? I'm assuming the ouside wheel /tire edge will sit similar to where it is now? I dont want it sticking out much further or past the fender.
Would the revised specs on this wheel, after widening, be a 12 inch wheel with approx et23?
I know guys like D'Gatzby, Paul @ pk Auto Design have a ton of knowledge about these cars, especially regarding tire fitment/performance. Any info would be greatly appreciated. Thanks to all the guys that post regularly on this board. I've been reading it for years. You're a great source of information for Hellcat owners.
Shout out to cole3986, tricolorpit, Djason, cra97 and all the guys searching for traction with wider rubber😁
